Commercial Fryer Repair in Matthews, NC
From downtown Matthews on Trade Street to Independence Boulevard (US-74), we provide commercial fryer repair for Matthews restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
A down fryer can stop a whole menu. We repair gas and electric open fryers, pressure fryers, filtration systems and computerized fryer controls.
Commercial Fryer repair for Matthews businesses
Matthews combines a walkable downtown restaurant row with heavy retail along US-74 and a busy medical corridor. We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your commercial fryer to hold those numbers. Our technicians are in Matthews most days of the week, so a call from a business on Sycamore Commons usually fits into the same day's route. When a part is not on the truck, we order it the same day from Charlotte-area suppliers and come back to Independence Boulevard (US-74) as soon as it arrives. We document every visit with the temperatures we measured and the parts we replaced, which helps Matthews managers with inspections and budgeting.
Signs you need commercial fryer repair
- Computer showing errors
- Pilot goes out
- High-limit tripping
- Fryer won't light or heat
- Oil overheating or not reaching set point
- Filter pump not running
What our technicians do
Fryers fail from bad pilots, thermopiles, gas valves, high-limit switches, temperature probes and filter pumps. We fix them fast so oil stays at temperature.
- Drain valve repair
- Controller replacement
- Filter pump and motor repair
- Temperature probe and thermostat replacement
- High-limit switch replacement
- Pilot, thermopile and gas valve replacement
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Walk-In CoolerGrocery Stores & Supermarkets
Walk-in cooler slowly warming over several days
- What we found
- Condenser coil packed with dust and cottonwood; high head pressure
- What we did
- Deep-cleaned the condenser, checked charge and amperage
✓ Typically fixed in one visit
- Refrigerated Display CaseGrocery Stores & Supermarkets
Glass-door merchandiser fogging up
- What we found
- Door anti-sweat heater failed
- What we did
- Replaced the door heater and checked the controller
✓ Typically fixed in one visit
- Mixer, Slicer & Food PrepBakeries
Planetary mixer grinding in second speed
- What we found
- Worn transmission gear
- What we did
- Replaced the gear and lubricated the gearbox
✓ Usually needs a part ordered — two visits
- Soft Serve & Frozen Drink MachineIce Cream & Frozen Yogurt Shops
Soft serve coming out runny
- What we found
- Dirty condenser and worn drive belt
- What we did
- Cleaned the condenser, replaced the belt, adjusted viscosity
✓ Typically fixed in one visit
- Steamer, Kettle & Braising PanSchools & Universities
Steamer showing low-water alarm
- What we found
- Scaled water level probe
- What we did
- Cleaned the probe and delimed the generator
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Common problems
Who we serve in Matthews
Technician tip
Filter oil daily and boil out the pot weekly — carbon on the probe throws off temperature.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my fryer keep shutting off?
Usually a weak thermopile, a failing gas valve or a high-limit switch tripping.
Do you repair pressure fryers?
Yes, including lid, gasket and pressure system repairs.
How much does commercial fryer repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Matthews and all of Matthews, NC, including ZIP codes 28104, 28105.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |