Commercial Fryer Repair in Pineville, NC
When a commercial fryer goes down in Pineville, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit. A down fryer can stop a whole menu. We repair gas and electric open fryers, pressure fryers, filtration systems and computerized fryer controls.
Commercial Fryer repair for Pineville businesses
Pineville is a retail hub on the Charlotte–South Carolina line, packed with chain restaurants, fast casual concepts and big-box grocery around Carolina Place. We serve businesses near Carolina Place Mall, Polk Street and NC-51, including ZIP codes 28134 in Mecklenburg County, NC.
Because we also work in Ballantyne and Charlotte, a technician is often already nearby when a Pineville business calls. Businesses in ZIP 28134 can book online in 30 seconds, and the first available operator calls back during business hours. If a repair is not worth the money, we tell you and quote the replacement — no Pineville customer is pushed into a new unit they don't need. Our technicians are in Pineville most days of the week, so a call from a business on NC-51 usually fits into the same day's route.
Signs you need commercial fryer repair
- Computer showing errors
- Filter pump not running
- Pilot goes out
- Oil overheating or not reaching set point
- High-limit tripping
- Fryer won't light or heat
What our technicians do
Fryers fail from bad pilots, thermopiles, gas valves, high-limit switches, temperature probes and filter pumps. We fix them fast so oil stays at temperature.
- Temperature probe and thermostat replacement
- Controller replacement
- Pilot, thermopile and gas valve replacement
- Filter pump and motor repair
- Drain valve repair
- High-limit switch replacement
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
- Ice MachineConvenience Stores & Gas Stations
Ice machine showing a flashing error light
- What we found
- Water inlet valve not opening
- What we did
- Replaced the inlet valve and verified full fill
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Common problems
Who we serve in Pineville
Technician tip
Filter oil daily and boil out the pot weekly — carbon on the probe throws off temperature.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my fryer keep shutting off?
Usually a weak thermopile, a failing gas valve or a high-limit switch tripping.
Do you repair pressure fryers?
Yes, including lid, gasket and pressure system repairs.
How much does commercial fryer repair cost in Pineville, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Pineville?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28134?
Yes. We serve Pineville and all of Pineville, NC, including ZIP codes 28134.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Pineville, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |