Commercial Fryer Repair in Stallings, NC
Stallings businesses call us for fast, honest commercial fryer repair.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
You get a flat $135 service call and a written price before any work starts. A down fryer can stop a whole menu. We repair gas and electric open fryers, pressure fryers, filtration systems and computerized fryer controls.
Commercial Fryer repair for Stallings businesses
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
Our technicians are in Stallings most days of the week, so a call from a business on Idlewild Road usually fits into the same day's route. Businesses in ZIP 28104 can book online in 30 seconds, and the first available operator calls back during business hours. If a repair is not worth the money, we tell you and quote the replacement — no Stallings customer is pushed into a new unit they don't need. Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your commercial fryer to hold those numbers.
Signs you need commercial fryer repair
- Computer showing errors
- Fryer won't light or heat
- Pilot goes out
- Oil overheating or not reaching set point
- Filter pump not running
- High-limit tripping
What our technicians do
Fryers fail from bad pilots, thermopiles, gas valves, high-limit switches, temperature probes and filter pumps. We fix them fast so oil stays at temperature.
- Controller replacement
- Drain valve repair
- High-limit switch replacement
- Pilot, thermopile and gas valve replacement
- Filter pump and motor repair
- Temperature probe and thermostat replacement
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Common problems
Who we serve in Stallings
Technician tip
Filter oil daily and boil out the pot weekly — carbon on the probe throws off temperature.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my fryer keep shutting off?
Usually a weak thermopile, a failing gas valve or a high-limit switch tripping.
Do you repair pressure fryers?
Yes, including lid, gasket and pressure system repairs.
How much does commercial fryer repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Stallings and all of Stallings, NC, including ZIP codes 28104.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |