Delfield Repair in Matthews, NC
From downtown Matthews on Trade Street to Independence Boulevard (US-74), we provide Delfield repair for Matthews restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Delfield makes reach-ins, prep tables, chef bases and refrigerated wells, and we repair them on-site.
Delfield service for Matthews businesses
Matthews combines a walkable downtown restaurant row with heavy retail along US-74 and a busy medical corridor. We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
From quick-service counters near Sycamore Commons to full kitchens near downtown Matthews on Trade Street, Matthews businesses rely on us for Delfield work. Our technicians are in Matthews most days of the week, so a call from a business on Sycamore Commons usually fits into the same day's route. Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Delfield to hold those numbers. Many of our Matthews customers are along downtown Matthews on Trade Street and Matthews Township Parkway, where busy kitchens run Delfield equipment hard from open to close.
Delfield problems we fix in Matthews
- Delfield reach-in refrigerator: not cold enough or temperature swings
- Delfield reach-in refrigerator: gasket torn or door sagging
- Delfield reach-in freezer: door hard to open or not sealing
- Delfield reach-in freezer: water or ice under the unit
- Delfield prep table and sandwich unit: cabinet cold but rail warm
- Delfield prep table and sandwich unit: water leaking into the cabinet
- Delfield undercounter and worktop refrigerator: not holding temperature during service
- Delfield undercounter and worktop refrigerator: drawers not sealing
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Commercial OvenBakeries
Convection oven baking unevenly
- What we found
- Blower motor bearings worn
- What we did
- Replaced the convection blower motor
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Other brands in Matthews
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Delfield equipment in Matthews?
Yes. We repair Delfield reach-in refrigerator, reach-in freezer, prep table and sandwich unit, undercounter and worktop refrigerator for businesses throughout Matthews, NC.
Are you an authorized Delfield dealer?
No — we are an independent commercial service company. We repair Delfield equipment and warranty our work for 30 days labor and 90 days parts.
How much does Delfield repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |