Master-Bilt Repair in Matthews, NC
When a Master-Bilt walk-in cooler goes down in Matthews, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit. Master-Bilt makes walk-ins, ice cream and display freezers, and refrigeration systems, and we repair them on-site.
Master-Bilt service for Matthews businesses
Matthews combines a walkable downtown restaurant row with heavy retail along US-74 and a busy medical corridor. We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Master-Bilt to hold those numbers. Many of our Matthews customers are along downtown Matthews on Trade Street and Matthews Township Parkway, where busy kitchens run Master-Bilt equipment hard from open to close. From quick-service counters near Sycamore Commons to full kitchens near downtown Matthews on Trade Street, Matthews businesses rely on us for Master-Bilt work. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Matthews kitchens we check airflow, coil condition and electrical parts on every visit.
Master-Bilt problems we fix in Matthews
- Master-Bilt walk-in cooler: water leaking onto the floor or dripping from the ceiling unit
- Master-Bilt walk-in cooler: ice building on the evaporator coil
- Master-Bilt walk-in freezer: compressor running constantly
- Master-Bilt walk-in freezer: freezer above 0°f or ice cream turning soft
Master-Bilt equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Walk-In FreezerRestaurants
Walk-in freezer iced solid, product softening
- What we found
- Defrost termination thermostat failed
- What we did
- Replaced the thermostat, defrosted the coil, confirmed -5°F
✓ Typically fixed in one visit
- Walk-In CoolerGrocery Stores & Supermarkets
Walk-in cooler slowly warming over several days
- What we found
- Condenser coil packed with dust and cottonwood; high head pressure
- What we did
- Deep-cleaned the condenser, checked charge and amperage
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Walk-In CoolerRestaurants
Walk-in cooler at 48°F before dinner service
- What we found
- Evaporator fan motor seized; coil starting to ice
- What we did
- Replaced the fan motor, cleared the coil, verified 36°F box temperature
✓ Typically fixed in one visit
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Master-Bilt equipment in Matthews?
Yes. We repair Master-Bilt walk-in cooler, walk-in freezer for businesses throughout Matthews, NC.
Are you an authorized Master-Bilt dealer?
No — we are an independent commercial service company. We repair Master-Bilt equipment and warranty our work for 30 days labor and 90 days parts.
How much does Master-Bilt repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |