Reach-In Freezer Repair in Stallings, NC
Stallings businesses call us for fast, honest reach-in freezer repair.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
You get a flat $135 service call and a written price before any work starts. Reach-in freezers keep fries, proteins and desserts at 0°F or below on the line. We repair single- and multi-door commercial freezers, including units with electronic controllers and automatic defrost.
Reach-In Freezer repair for Stallings businesses
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
From quick-service counters near Idlewild Road to full kitchens near US-74, Stallings businesses rely on us for reach-in freezer work. When a part is not on the truck, we order it the same day from Charlotte-area suppliers and come back to Stallings Road as soon as it arrives. Businesses in ZIP 28104 can book online in 30 seconds, and the first available operator calls back during business hours. We document every visit with the temperatures we measured and the parts we replaced, which helps Stallings managers with inspections and budgeting.
Signs you need reach-in freezer repair
- Door hard to open or not sealing
- Product softening or above 0°F
- Constant running
- Heavy frost on the coil or walls
- Water or ice under the unit
- Controller showing alarms
What our technicians do
Freezers fail most often from defrost problems, failed fan motors, dirty condensers and worn door gaskets that let warm, humid air in. We restore temperature and fix what caused the failure.
- Leak repair and recharge
- Compressor replacement
- Gasket and door heater replacement
- Condenser cleaning
- Defrost system repair
- Fan motor and controller replacement
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Condensing Unit & CompressorGrocery Stores & Supermarkets
Rooftop condensing unit tripping the breaker
- What we found
- Shorted condenser fan motor
- What we did
- Replaced the fan motor and checked electrical connections
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Walk-In CoolerGrocery Stores & Supermarkets
Walk-in cooler slowly warming over several days
- What we found
- Condenser coil packed with dust and cottonwood; high head pressure
- What we did
- Deep-cleaned the condenser, checked charge and amperage
✓ Typically fixed in one visit
- Steamer, Kettle & Braising PanSchools & Universities
Steamer showing low-water alarm
- What we found
- Scaled water level probe
- What we did
- Cleaned the probe and delimed the generator
✓ Typically fixed in one visit
- Walk-In FreezerRestaurants
Walk-in freezer iced solid, product softening
- What we found
- Defrost termination thermostat failed
- What we did
- Replaced the thermostat, defrosted the coil, confirmed -5°F
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Common problems
Technician tip
Don't block the air vent at the top of the cabinet with boxes — freezers need that airflow to defrost properly.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my commercial freezer keep frosting up?
Usually a defrost failure or a door gasket that no longer seals. Both are routine repairs.
Should I unplug the freezer to defrost it?
Only as a temporary fix. If it ices up again in a few days, a defrost part has failed and needs to be replaced.
How much does reach-in freezer repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Stallings and all of Stallings, NC, including ZIP codes 28104.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |