Traulsen Repair in Stallings, NC
Need Traulsen repair in Stallings, NC? We send commercial technicians to restaurants, bars, stores and institutional kitchens across Stallings every week.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Traulsen makes reach-in and roll-in refrigerators, freezers and blast chillers, and we repair them on-site.
Traulsen service for Stallings businesses
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
We document every visit with the temperatures we measured and the parts we replaced, which helps Stallings managers with inspections and budgeting. Many of our Stallings customers are along US-74 and Matthews-Indian Trail Road, where busy kitchens run Traulsen equipment hard from open to close. Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Traulsen to hold those numbers. Our technicians are in Stallings most days of the week, so a call from a business on Idlewild Road usually fits into the same day's route.
Traulsen problems we fix in Stallings
- Traulsen reach-in refrigerator: not cold enough or temperature swings
- Traulsen reach-in refrigerator: water under the unit
- Traulsen reach-in freezer: controller showing alarms
- Traulsen reach-in freezer: constant running
- Traulsen prep table and sandwich unit: compressor overheating
- Traulsen prep table and sandwich unit: cabinet cold but rail warm
- Traulsen undercounter and worktop refrigerator: not holding temperature during service
- Traulsen undercounter and worktop refrigerator: chef base sagging or drawers sticking
- Traulsen blast chiller: fans not running
- Traulsen blast chiller: alarm codes
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Traulsen equipment in Stallings?
Yes. We repair Traulsen reach-in refrigerator, reach-in freezer, prep table and sandwich unit, undercounter and worktop refrigerator, blast chiller for businesses throughout Stallings, NC.
Are you an authorized Traulsen dealer?
No — we are an independent commercial service company. We repair Traulsen equipment and warranty our work for 30 days labor and 90 days parts.
How much does Traulsen repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |