Prep Table & Sandwich Unit Repair in Stallings, NC
Need prep table and sandwich unit repair in Stallings, NC? We send commercial technicians to restaurants, bars, stores and institutional kitchens across Stallings every week.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Sandwich, salad and pizza prep tables are some of the hardest-working refrigeration on the line. Pans on top have to stay at 41°F or below while the lid is open for hours. We repair sandwich/salad units, mega-top units and pizza prep tables.
Prep Table & Sandwich Unit repair for Stallings businesses
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Stallings kitchens we check airflow, coil condition and electrical parts on every visit. Our technicians are in Stallings most days of the week, so a call from a business on Idlewild Road usually fits into the same day's route. Businesses in ZIP 28104 can book online in 30 seconds, and the first available operator calls back during business hours. Many of our Stallings customers are along US-74 and Matthews-Indian Trail Road, where busy kitchens run prep table and sandwich unit equipment hard from open to close.
Signs you need prep table and sandwich unit repair
- Compressor overheating
- Water leaking into the cabinet
- Lid hinge broken or lid not closing
- Top rail pans above 41°F
- Cabinet cold but rail warm
- Ice on the coil
What our technicians do
Warm rail pans are the classic complaint. The causes are usually a dirty condenser, a weak evaporator fan, a blocked air duct to the rail, low refrigerant or a failed thermostat.
- Thermostat and controller replacement
- Condenser cleaning
- Lid hinge and gasket replacement
- Rail airflow and duct repair
- Fan motor replacement
- Leak repair and recharge
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Prep Table & Sandwich Unit brands we repair in Stallings
Common problems
Who we serve in Stallings
Technician tip
Close the rail lid during slow periods — it cuts compressor run time and keeps pans at a safe temperature.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why are my prep table pans warm but the cabinet is cold?
The rail depends on airflow from the evaporator. A weak fan, iced coil or blocked duct starves the pans first.
Can a prep table hold food safely overnight in the rail?
Most manufacturers recommend moving pans to the cabinet or a walk-in overnight; rail units are designed for service hours.
How much does prep table and sandwich unit repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Stallings and all of Stallings, NC, including ZIP codes 28104.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |