Griddle & Charbroiler Repair in Stallings, NC
Need griddle and charbroiler repair in Stallings, NC? We send commercial technicians to restaurants, bars, stores and institutional kitchens across Stallings every week.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
We repair gas and electric griddles, flat tops, clamshell grills, charbroilers and salamanders so you get even heat across the whole cooking surface.
Griddle & Charbroiler repair for Stallings businesses
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your griddle and charbroiler to hold those numbers. When a part is not on the truck, we order it the same day from Charlotte-area suppliers and come back to Stallings Road as soon as it arrives. From quick-service counters near Idlewild Road to full kitchens near US-74, Stallings businesses rely on us for griddle and charbroiler work. Because we also work in Matthews and Indian Trail, a technician is often already nearby when a Stallings business calls.
Signs you need griddle and charbroiler repair
- Pilot going out
- Charbroiler flames uneven
- Clamshell platen not heating
- Cold spots on the griddle
- Burner won't light
- Temperature not matching the dial
What our technicians do
Cold spots, burners that won't light and thermostats that drift are the usual problems.
- Element replacement (electric)
- Radiant and grate replacement
- Burner and pilot repair
- Thermostat replacement and calibration
- Gas valve replacement
- Clamshell controls repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Griddle & CharbroilerFood Trucks
Griddle has a cold spot on one side
- What we found
- Clogged burner ports
- What we did
- Cleaned and adjusted the burner, checked the thermostat
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Condensing Unit & CompressorGrocery Stores & Supermarkets
Rooftop condensing unit tripping the breaker
- What we found
- Shorted condenser fan motor
- What we did
- Replaced the fan motor and checked electrical connections
✓ Typically fixed in one visit
- Steamer, Kettle & Braising PanSchools & Universities
Steamer showing low-water alarm
- What we found
- Scaled water level probe
- What we did
- Cleaned the probe and delimed the generator
✓ Typically fixed in one visit
- Draft Beer & Keg CoolerBreweries & Taprooms
Foamy pours on every tap
- What we found
- Glycol chiller pump failing, lines warming
- What we did
- Replaced the glycol pump and topped up glycol
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Griddle & Charbroiler brands we repair in Stallings
Who we serve in Stallings
Technician tip
Season and scrape the griddle daily; heavy carbon acts as insulation and creates cold spots.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my griddle have cold spots?
A clogged burner, failed thermostat or warped plate. Most are repairable.
Do you repair salamanders and cheese melters?
Yes.
How much does griddle and charbroiler repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Stallings and all of Stallings, NC, including ZIP codes 28104.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |