Prep Table & Sandwich Unit Repair in Plaza Midwood, Charlotte
From Central Avenue to The Plaza, we provide prep table and sandwich unit repair for Plaza Midwood restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Sandwich, salad and pizza prep tables are some of the hardest-working refrigeration on the line. Pans on top have to stay at 41°F or below while the lid is open for hours. We repair sandwich/salad units, mega-top units and pizza prep tables.
Prep Table & Sandwich Unit repair for Plaza Midwood businesses
Plaza Midwood's independent restaurants, bars and cafés line Central Avenue and The Plaza. We serve businesses near Central Avenue, The Plaza and Commonwealth Avenue, including ZIP codes 28205 in Mecklenburg County, NC.
We document every visit with the temperatures we measured and the parts we replaced, which helps Plaza Midwood managers with inspections and budgeting. Businesses in ZIP 28205 can book online in 30 seconds, and the first available operator calls back during business hours. Our technicians are in Plaza Midwood most days of the week, so a call from a business on Commonwealth Avenue usually fits into the same day's route. Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your prep table and sandwich unit to hold those numbers.
Signs you need prep table and sandwich unit repair
- Water leaking into the cabinet
- Cabinet cold but rail warm
- Ice on the coil
- Top rail pans above 41°F
- Lid hinge broken or lid not closing
- Compressor overheating
What our technicians do
Warm rail pans are the classic complaint. The causes are usually a dirty condenser, a weak evaporator fan, a blocked air duct to the rail, low refrigerant or a failed thermostat.
- Leak repair and recharge
- Thermostat and controller replacement
- Condenser cleaning
- Rail airflow and duct repair
- Fan motor replacement
- Lid hinge and gasket replacement
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial OvenBakeries
Convection oven baking unevenly
- What we found
- Blower motor bearings worn
- What we did
- Replaced the convection blower motor
✓ Typically fixed in one visit
- Refrigerated Display CaseBakeries
Bakery display case warm at the front
- What we found
- Evaporator iced from a bad defrost timer
- What we did
- Replaced the timer, defrosted, verified temperatures
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Prep Table & Sandwich Unit brands we repair in Plaza Midwood
Common problems
Who we serve in Plaza Midwood
Technician tip
Close the rail lid during slow periods — it cuts compressor run time and keeps pans at a safe temperature.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why are my prep table pans warm but the cabinet is cold?
The rail depends on airflow from the evaporator. A weak fan, iced coil or blocked duct starves the pans first.
Can a prep table hold food safely overnight in the rail?
Most manufacturers recommend moving pans to the cabinet or a walk-in overnight; rail units are designed for service hours.
How much does prep table and sandwich unit repair cost in Plaza Midwood, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Plaza Midwood?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28205?
Yes. We serve Plaza Midwood and all of Plaza Midwood, Charlotte, including ZIP codes 28205.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Plaza Midwood, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |