Traulsen Repair in South End, Charlotte
Our Traulsen repair service covers all of South End, Charlotte.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
We know the local businesses, the building types and how hot a South End kitchen gets in July. Traulsen makes reach-in and roll-in refrigerators, freezers and blast chillers, and we repair them on-site.
Traulsen service for South End businesses
South End is packed with breweries, taprooms, cafés and new restaurants along the light rail — draft systems, ice machines and bar coolers are everywhere. We serve businesses near the Rail Trail, Camden Road and South Boulevard, including ZIP codes 28203 in Mecklenburg County, NC.
Summer heat in the Charlotte region pushes condensers and compressors to their limit; for South End kitchens we check airflow, coil condition and electrical parts on every visit. We document every visit with the temperatures we measured and the parts we replaced, which helps South End managers with inspections and budgeting. If a repair is not worth the money, we tell you and quote the replacement — no South End customer is pushed into a new unit they don't need. Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Traulsen to hold those numbers.
Traulsen problems we fix in South End
- Traulsen reach-in refrigerator: compressor clicking on and off
- Traulsen reach-in refrigerator: not cold enough or temperature swings
- Traulsen reach-in freezer: controller showing alarms
- Traulsen reach-in freezer: heavy frost on the coil or walls
- Traulsen prep table and sandwich unit: compressor overheating
- Traulsen prep table and sandwich unit: water leaking into the cabinet
- Traulsen undercounter and worktop refrigerator: noisy operation
- Traulsen undercounter and worktop refrigerator: chef base sagging or drawers sticking
- Traulsen blast chiller: alarm codes
- Traulsen blast chiller: probe errors
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Ice MachineConvenience Stores & Gas Stations
Ice machine showing a flashing error light
- What we found
- Water inlet valve not opening
- What we did
- Replaced the inlet valve and verified full fill
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Traulsen equipment in South End?
Yes. We repair Traulsen reach-in refrigerator, reach-in freezer, prep table and sandwich unit, undercounter and worktop refrigerator, blast chiller for businesses throughout South End, Charlotte.
Are you an authorized Traulsen dealer?
No — we are an independent commercial service company. We repair Traulsen equipment and warranty our work for 30 days labor and 90 days parts.
How much does Traulsen repair cost in South End, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in South End?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve South End, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |