Hobart Repair in South End, Charlotte
When a Hobart commercial dishwasher goes down in South End, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit. Hobart makes dishwashers, mixers and slicers, and we repair them on-site.
Hobart service for South End businesses
South End is packed with breweries, taprooms, cafés and new restaurants along the light rail — draft systems, ice machines and bar coolers are everywhere. We serve businesses near the Rail Trail, Camden Road and South Boulevard, including ZIP codes 28203 in Mecklenburg County, NC.
Businesses in ZIP 28203 can book online in 30 seconds, and the first available operator calls back during business hours. Because we also work in Uptown Charlotte and Dilworth, a technician is often already nearby when a South End business calls. Our technicians are in South End most days of the week, so a call from a business on South Boulevard usually fits into the same day's route. We document every visit with the temperatures we measured and the parts we replaced, which helps South End managers with inspections and budgeting.
Hobart problems we fix in South End
- Hobart commercial dishwasher: leaking
- Hobart commercial dishwasher: booster heater not heating
- Hobart mixer, slicer and food prep: slicer blade dull or wobbly
- Hobart mixer, slicer and food prep: safety interlock fault
Hobart equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Mixer, Slicer & Food PrepBakeries
Planetary mixer grinding in second speed
- What we found
- Worn transmission gear
- What we did
- Replaced the gear and lubricated the gearbox
✓ Usually needs a part ordered — two visits
- Commercial DishwasherRestaurants
Dishwasher not draining
- What we found
- Drain valve stuck with debris
- What we did
- Cleared and rebuilt the drain valve
✓ Typically fixed in one visit
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
- Draft Beer & Keg CoolerBreweries & Taprooms
Foamy pours on every tap
- What we found
- Glycol chiller pump failing, lines warming
- What we did
- Replaced the glycol pump and topped up glycol
✓ Typically fixed in one visit
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Walk-In CoolerRestaurants
Walk-in cooler at 48°F before dinner service
- What we found
- Evaporator fan motor seized; coil starting to ice
- What we did
- Replaced the fan motor, cleared the coil, verified 36°F box temperature
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Hobart equipment in South End?
Yes. We repair Hobart commercial dishwasher, mixer, slicer and food prep for businesses throughout South End, Charlotte.
Are you an authorized Hobart dealer?
No — we are an independent commercial service company. We repair Hobart equipment and warranty our work for 30 days labor and 90 days parts.
How much does Hobart repair cost in South End, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in South End?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve South End, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |