Henny Penny Repair in Plaza Midwood, Charlotte
When a Henny Penny commercial fryer goes down in Plaza Midwood, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit. Henny Penny makes pressure fryers, open fryers and holding cabinets, and we repair them on-site.
Henny Penny service for Plaza Midwood businesses
Plaza Midwood's independent restaurants, bars and cafés line Central Avenue and The Plaza. We serve businesses near Central Avenue, The Plaza and Commonwealth Avenue, including ZIP codes 28205 in Mecklenburg County, NC.
Businesses in ZIP 28205 can book online in 30 seconds, and the first available operator calls back during business hours. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Plaza Midwood kitchens we check airflow, coil condition and electrical parts on every visit. Many of our Plaza Midwood customers are along Central Avenue and Thomas Street, where busy kitchens run Henny Penny equipment hard from open to close. Because we also work in NoDa and Elizabeth, a technician is often already nearby when a Plaza Midwood business calls.
Henny Penny problems we fix in Plaza Midwood
- Henny Penny commercial fryer: filter pump not running
- Henny Penny commercial fryer: fryer won't light or heat
Henny Penny equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Soft Serve & Frozen Drink MachineIce Cream & Frozen Yogurt Shops
Soft serve coming out runny
- What we found
- Dirty condenser and worn drive belt
- What we did
- Cleaned the condenser, replaced the belt, adjusted viscosity
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Refrigerated Display CaseGrocery Stores & Supermarkets
Glass-door merchandiser fogging up
- What we found
- Door anti-sweat heater failed
- What we did
- Replaced the door heater and checked the controller
✓ Typically fixed in one visit
- Refrigerated Display CaseBakeries
Bakery display case warm at the front
- What we found
- Evaporator iced from a bad defrost timer
- What we did
- Replaced the timer, defrosted, verified temperatures
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Other brands in Plaza Midwood
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Henny Penny equipment in Plaza Midwood?
Yes. We repair Henny Penny commercial fryer for businesses throughout Plaza Midwood, Charlotte.
Are you an authorized Henny Penny dealer?
No — we are an independent commercial service company. We repair Henny Penny equipment and warranty our work for 30 days labor and 90 days parts.
How much does Henny Penny repair cost in Plaza Midwood, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Plaza Midwood?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Plaza Midwood, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |