Commercial Dishwasher Repair in Monroe, NC
From downtown Monroe on Main Street to Roosevelt Boulevard (US-74), we provide commercial dishwasher repair for Monroe restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
When the dish machine goes down, the kitchen runs out of plates. We repair undercounter, door-type, conveyor and flight-type dishwashers, glass washers and booster heaters.
Commercial Dishwasher repair for Monroe businesses
Monroe is the Union County seat, with food manufacturing, a hospital, schools and a long restaurant and grocery corridor along US-74. We serve businesses near downtown Monroe on Main Street, Roosevelt Boulevard (US-74) and the Charlotte–Monroe Executive Airport area, including ZIP codes 28110, 28112 in Union County, NC.
We document every visit with the temperatures we measured and the parts we replaced, which helps Monroe managers with inspections and budgeting. Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your commercial dishwasher to hold those numbers. Because we also work in Indian Trail and Wesley Chapel, a technician is often already nearby when a Monroe business calls. Businesses in ZIP 28110 and 28112 can book online in 30 seconds, and the first available operator calls back during business hours.
Signs you need commercial dishwasher repair
- Wash arm not spinning
- Machine not filling or not draining
- Dishes not coming out clean
- Booster heater not heating
- Leaking
- Rinse not hot enough (below 180°F on hot-water units)
What our technicians do
Low rinse temperature, failed booster heaters, pump motors, solenoids, chemical feeders and drain valves are the most common repairs. We verify final rinse temperature before we leave.
- Wash and rinse pump repair
- Fill solenoid and drain valve replacement
- Delime and cleaning
- Door and curtain repair
- Booster heater element and thermostat repair
- Float switch repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
- Commercial DishwasherRestaurants
Dishwasher not draining
- What we found
- Drain valve stuck with debris
- What we did
- Cleared and rebuilt the drain valve
✓ Typically fixed in one visit
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
- Ice MachineConvenience Stores & Gas Stations
Ice machine showing a flashing error light
- What we found
- Water inlet valve not opening
- What we did
- Replaced the inlet valve and verified full fill
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Walk-In FreezerRestaurants
Walk-in freezer iced solid, product softening
- What we found
- Defrost termination thermostat failed
- What we did
- Replaced the thermostat, defrosted the coil, confirmed -5°F
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Technician tip
Delime on schedule and check final rinse temperature daily — inspectors will.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why is my dishwasher rinse not hot enough?
Usually a failed booster heater element, thermostat or a scale-coated heater.
Do you repair low-temp chemical machines?
Yes, both high-temp and low-temp machines.
How much does commercial dishwasher repair cost in Monroe, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Monroe?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28110?
Yes. We serve Monroe and all of Monroe, NC, including ZIP codes 28110, 28112.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Monroe, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |