Brewery Equipment Repair in Stallings, NC
Looking for reliable brewery equipment repair near US-74? We serve Stallings, NC with same-day service when available.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Taprooms depend on keg walk-ins, glycol chillers and draft systems. We repair the refrigeration that keeps your beer at the right temperature from the cooler to the tap.
Problems we solve for Stallings brewerys
- Keg walk-in temperature swings
- Glycol chillers running warm
- Foaming at the tap
- Condensing units overloaded in summer
Local service
Stallings sits between Matthews and Indian Trail with restaurants, convenience stores and shopping centers along US-74. We serve businesses near US-74, Stallings Road and Idlewild Road, including ZIP codes 28104 in Union County, NC.
Our technicians are in Stallings most days of the week, so a call from a business on Idlewild Road usually fits into the same day's route. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Stallings kitchens we check airflow, coil condition and electrical parts on every visit. Because we also work in Matthews and Indian Trail, a technician is often already nearby when a Stallings business calls. Many of our Stallings customers are along US-74 and Matthews-Indian Trail Road, where busy kitchens run brewery equipment hard from open to close.
Equipment we repair for brewerys in Stallings
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Draft Beer & Keg CoolerBreweries & Taprooms
Foamy pours on every tap
- What we found
- Glycol chiller pump failing, lines warming
- What we did
- Replaced the glycol pump and topped up glycol
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Walk-In CoolerRestaurants
Walk-in cooler at 48°F before dinner service
- What we found
- Evaporator fan motor seized; coil starting to ice
- What we did
- Replaced the fan motor, cleared the coil, verified 36°F box temperature
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Walk-In CoolerGrocery Stores & Supermarkets
Walk-in cooler slowly warming over several days
- What we found
- Condenser coil packed with dust and cottonwood; high head pressure
- What we did
- Deep-cleaned the condenser, checked charge and amperage
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Technician tip
Track glycol bath temperature daily during summer — it is the first number to move when a chiller is struggling.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair equipment for brewerys in Stallings?
Yes. We repair walk-in cooler, draft beer and keg cooler, ice machine, bar cooler and back bar, condensing unit and compressor for brewerys throughout Stallings, NC.
How much does brewery equipment repair cost in Stallings, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Stallings?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Stallings and all of Stallings, NC, including ZIP codes 28104.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Stallings, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |