Griddle & Charbroiler Repair in Plaza Midwood, Charlotte
From Central Avenue to The Plaza, we provide griddle and charbroiler repair for Plaza Midwood restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
We repair gas and electric griddles, flat tops, clamshell grills, charbroilers and salamanders so you get even heat across the whole cooking surface.
Griddle & Charbroiler repair for Plaza Midwood businesses
Plaza Midwood's independent restaurants, bars and cafés line Central Avenue and The Plaza. We serve businesses near Central Avenue, The Plaza and Commonwealth Avenue, including ZIP codes 28205 in Mecklenburg County, NC.
We document every visit with the temperatures we measured and the parts we replaced, which helps Plaza Midwood managers with inspections and budgeting. Our technicians are in Plaza Midwood most days of the week, so a call from a business on Commonwealth Avenue usually fits into the same day's route. Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your griddle and charbroiler to hold those numbers. Many of our Plaza Midwood customers are along Central Avenue and Thomas Street, where busy kitchens run griddle and charbroiler equipment hard from open to close.
Signs you need griddle and charbroiler repair
- Charbroiler flames uneven
- Pilot going out
- Cold spots on the griddle
- Burner won't light
- Clamshell platen not heating
- Temperature not matching the dial
What our technicians do
Cold spots, burners that won't light and thermostats that drift are the usual problems.
- Gas valve replacement
- Thermostat replacement and calibration
- Radiant and grate replacement
- Element replacement (electric)
- Clamshell controls repair
- Burner and pilot repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Griddle & CharbroilerFood Trucks
Griddle has a cold spot on one side
- What we found
- Clogged burner ports
- What we did
- Cleaned and adjusted the burner, checked the thermostat
✓ Typically fixed in one visit
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Commercial OvenPizzerias
Conveyor pizza oven not reaching temperature
- What we found
- Failed igniter and flame sensor
- What we did
- Replaced igniter and sensor, verified bake temperature
✓ Typically fixed in one visit
- Commercial DishwasherRestaurants
Dishwasher not draining
- What we found
- Drain valve stuck with debris
- What we did
- Cleared and rebuilt the drain valve
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Griddle & Charbroiler brands we repair in Plaza Midwood
Who we serve in Plaza Midwood
Technician tip
Season and scrape the griddle daily; heavy carbon acts as insulation and creates cold spots.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why does my griddle have cold spots?
A clogged burner, failed thermostat or warped plate. Most are repairable.
Do you repair salamanders and cheese melters?
Yes.
How much does griddle and charbroiler repair cost in Plaza Midwood, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Plaza Midwood?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28205?
Yes. We serve Plaza Midwood and all of Plaza Midwood, Charlotte, including ZIP codes 28205.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Plaza Midwood, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |