Henny Penny Repair in Piper Glen, Charlotte
When a Henny Penny commercial fryer goes down in Piper Glen, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit. Henny Penny makes pressure fryers, open fryers and holding cabinets, and we repair them on-site.
Henny Penny service for Piper Glen businesses
Piper Glen sits between Ballantyne and Blakeney, close to country clubs and restaurant corridors on Rea Road. We serve businesses near Rea Road, Piper Glen Drive and Carmel Road, including ZIP codes 28277 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Henny Penny to hold those numbers. Many of our Piper Glen customers are along Rea Road and the Ballantyne edge of I-485, where busy kitchens run Henny Penny equipment hard from open to close. Our technicians are in Piper Glen most days of the week, so a call from a business on Carmel Road usually fits into the same day's route. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Piper Glen kitchens we check airflow, coil condition and electrical parts on every visit.
Henny Penny problems we fix in Piper Glen
- Henny Penny commercial fryer: high-limit tripping
- Henny Penny commercial fryer: oil overheating or not reaching set point
Henny Penny equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Coffee & Beverage EquipmentCafés & Coffee Shops
Coffee brewer not hot
- What we found
- Scale-coated heating element
- What we did
- Replaced the element, descaled the tank
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
- Ice MachineConvenience Stores & Gas Stations
Ice machine showing a flashing error light
- What we found
- Water inlet valve not opening
- What we did
- Replaced the inlet valve and verified full fill
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Henny Penny equipment in Piper Glen?
Yes. We repair Henny Penny commercial fryer for businesses throughout Piper Glen, Charlotte.
Are you an authorized Henny Penny dealer?
No — we are an independent commercial service company. We repair Henny Penny equipment and warranty our work for 30 days labor and 90 days parts.
How much does Henny Penny repair cost in Piper Glen, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Piper Glen?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Piper Glen, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |