Steamer, Kettle & Braising Pan Repair in Myers Park, Charlotte
Looking for reliable steamer, kettle and braising pan repair near Queens Road? We serve Myers Park, Charlotte with same-day service when available.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Steamers, steam kettles and tilting skillets are workhorses in schools, hospitals and high-volume kitchens. We repair connectionless and boiler steamers, jacketed kettles and braising pans.
Steamer, Kettle & Braising Pan repair for Myers Park businesses
Myers Park's restaurants, clubs, school dining halls and specialty grocers serve one of Charlotte's oldest neighborhoods. We serve businesses near Queens Road, Selwyn Avenue and Providence Road, including ZIP codes 28207, 28209 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your steamer, kettle and braising pan to hold those numbers. If a repair is not worth the money, we tell you and quote the replacement — no Myers Park customer is pushed into a new unit they don't need. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Myers Park kitchens we check airflow, coil condition and electrical parts on every visit. We document every visit with the temperatures we measured and the parts we replaced, which helps Myers Park managers with inspections and budgeting.
Signs you need steamer, kettle and braising pan repair
- Tilt mechanism stuck
- Water leaking
- Low-water alarms
- Scale build-up
- No steam or slow cooking
- Kettle not heating
What our technicians do
Scale, failed water level probes, heating elements, solenoid valves and tilt mechanisms cause most breakdowns.
- Water level probe replacement
- Control board replacement
- Descaling and boiler cleaning
- Solenoid valve replacement
- Element and burner repair
- Tilt gear repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Steamer, Kettle & Braising PanSchools & Universities
Steamer showing low-water alarm
- What we found
- Scaled water level probe
- What we did
- Cleaned the probe and delimed the generator
✓ Typically fixed in one visit
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Mixer, Slicer & Food PrepBakeries
Planetary mixer grinding in second speed
- What we found
- Worn transmission gear
- What we did
- Replaced the gear and lubricated the gearbox
✓ Usually needs a part ordered — two visits
- Walk-In FreezerRestaurants
Walk-in freezer iced solid, product softening
- What we found
- Defrost termination thermostat failed
- What we did
- Replaced the thermostat, defrosted the coil, confirmed -5°F
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Steamer, Kettle & Braising Pan brands we repair in Myers Park
Common problems
Technician tip
Follow the descaling schedule — hard water scale is the leading cause of steamer failure.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
How often should a steamer be descaled?
Depends on water hardness; typically monthly to quarterly.
Do you repair tilt skillets?
Yes, including tilt gears, elements and controls.
How much does steamer, kettle and braising pan repair cost in Myers Park, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Myers Park?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28207?
Yes. We serve Myers Park and all of Myers Park, Charlotte, including ZIP codes 28207, 28209.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Myers Park, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |