Pitco Repair in Monroe, NC
Need Pitco repair in Monroe, NC? We send commercial technicians to restaurants, bars, stores and institutional kitchens across Monroe every week.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Pitco makes gas and electric fryers, and we repair them on-site.
Pitco service for Monroe businesses
Monroe is the Union County seat, with food manufacturing, a hospital, schools and a long restaurant and grocery corridor along US-74. We serve businesses near downtown Monroe on Main Street, Roosevelt Boulevard (US-74) and the Charlotte–Monroe Executive Airport area, including ZIP codes 28110, 28112 in Union County, NC.
Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Monroe kitchens we check airflow, coil condition and electrical parts on every visit. When a part is not on the truck, we order it the same day from Charlotte-area suppliers and come back to Roosevelt Boulevard (US-74) as soon as it arrives. Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Pitco to hold those numbers. We document every visit with the temperatures we measured and the parts we replaced, which helps Monroe managers with inspections and budgeting.
Pitco problems we fix in Monroe
- Pitco commercial fryer: high-limit tripping
- Pitco commercial fryer: pilot goes out
Pitco equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Walk-In CoolerRestaurants
Walk-in cooler at 48°F before dinner service
- What we found
- Evaporator fan motor seized; coil starting to ice
- What we did
- Replaced the fan motor, cleared the coil, verified 36°F box temperature
✓ Typically fixed in one visit
- Refrigerated Display CaseGrocery Stores & Supermarkets
Glass-door merchandiser fogging up
- What we found
- Door anti-sweat heater failed
- What we did
- Replaced the door heater and checked the controller
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Blast ChillerCatering & Commissary Kitchens
Blast chiller cycles taking too long
- What we found
- Food probe reading wrong and dirty condenser
- What we did
- Replaced the probe, cleaned the condenser
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Steamer, Kettle & Braising PanSchools & Universities
Steamer showing low-water alarm
- What we found
- Scaled water level probe
- What we did
- Cleaned the probe and delimed the generator
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Pitco equipment in Monroe?
Yes. We repair Pitco commercial fryer for businesses throughout Monroe, NC.
Are you an authorized Pitco dealer?
No — we are an independent commercial service company. We repair Pitco equipment and warranty our work for 30 days labor and 90 days parts.
How much does Pitco repair cost in Monroe, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Monroe?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Monroe, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |