Walk-In Freezer Icing Up — Repair in Matthews, NC
Walk-In Freezer Icing Up in Matthews, NC? Looking for reliable walk-in freezer repair near downtown Matthews on Trade Street? We serve Matthews, NC with same-day service when available.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Likely causes
- Door left open during deliveries
- Failed defrost heater or timer
- Bad termination thermostat
- Torn door gasket or failed door heater
- Frozen drain line
What to do before we arrive
- Keep the door closed
- Don't chip ice off the coil with tools — it punctures tubing
- Move product if temperature is above 0°F
Local service
We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
Many of our Matthews customers are along downtown Matthews on Trade Street and Matthews Township Parkway, where busy kitchens run walk-in freezer equipment hard from open to close. Businesses in ZIP 28104 and 28105 can book online in 30 seconds, and the first available operator calls back during business hours. From quick-service counters near Sycamore Commons to full kitchens near downtown Matthews on Trade Street, Matthews businesses rely on us for walk-in freezer work. Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your walk-in freezer to hold those numbers.
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Walk-In FreezerRestaurants
Walk-in freezer iced solid, product softening
- What we found
- Defrost termination thermostat failed
- What we did
- Replaced the thermostat, defrosted the coil, confirmed -5°F
✓ Typically fixed in one visit
- Walk-In FreezerIce Cream & Frozen Yogurt Shops
Freezer drain line frozen, water pooling
- What we found
- Drain line heater burned out
- What we did
- Installed a new drain line heater and cleared the line
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Mixer, Slicer & Food PrepBakeries
Planetary mixer grinding in second speed
- What we found
- Worn transmission gear
- What we did
- Replaced the gear and lubricated the gearbox
✓ Usually needs a part ordered — two visits
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Commercial OvenBakeries
Convection oven baking unevenly
- What we found
- Blower motor bearings worn
- What we did
- Replaced the convection blower motor
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Frequently asked questions
Why is my walk-in freezer icing up?
Most often: failed defrost heater or timer; torn door gasket or failed door heater; frozen drain line; bad termination thermostat.
How much does walk-in freezer repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Matthews and all of Matthews, NC, including ZIP codes 28104, 28105.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |