Holding Cabinet Not Heating — Repair in Matthews, NC
Holding Cabinet Not Heating in Matthews, NC? Matthews businesses call us for fast, honest food warmer and holding cabinet repair.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
You get a flat $135 service call and a written price before any work starts.
Likely causes
- Door gasket worn
- Bad thermostat or controller
- Failed element
- Loose wiring
What to do before we arrive
- Check power and breaker
- Move food to another hot-holding unit
- Check food temperature
Local service
We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your food warmer and holding cabinet to hold those numbers. Many of our Matthews customers are along downtown Matthews on Trade Street and Matthews Township Parkway, where busy kitchens run food warmer and holding cabinet equipment hard from open to close. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Matthews kitchens we check airflow, coil condition and electrical parts on every visit. When a part is not on the truck, we order it the same day from Charlotte-area suppliers and come back to Independence Boulevard (US-74) as soon as it arrives.
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Food Warmer & Holding CabinetCountry Clubs & Event Venues
Holding cabinet not heating before an event
- What we found
- Failed heating element
- What we did
- Replaced the element and tested the thermostat
✓ Typically fixed in one visit
- Draft Beer & Keg CoolerBreweries & Taprooms
Foamy pours on every tap
- What we found
- Glycol chiller pump failing, lines warming
- What we did
- Replaced the glycol pump and topped up glycol
✓ Typically fixed in one visit
- Coffee & Beverage EquipmentCafés & Coffee Shops
Coffee brewer not hot
- What we found
- Scale-coated heating element
- What we did
- Replaced the element, descaled the tank
✓ Typically fixed in one visit
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Soft Serve & Frozen Drink MachineIce Cream & Frozen Yogurt Shops
Soft serve coming out runny
- What we found
- Dirty condenser and worn drive belt
- What we did
- Cleaned the condenser, replaced the belt, adjusted viscosity
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Frequently asked questions
Why is my holding cabinet not heating?
Most often: failed element; bad thermostat or controller; loose wiring; door gasket worn.
How much does food warmer and holding cabinet repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Matthews and all of Matthews, NC, including ZIP codes 28104, 28105.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |