Commercial Dishwasher Repair in Matthews, NC
Need commercial dishwasher repair in Matthews, NC? We send commercial technicians to restaurants, bars, stores and institutional kitchens across Matthews every week.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
When the dish machine goes down, the kitchen runs out of plates. We repair undercounter, door-type, conveyor and flight-type dishwashers, glass washers and booster heaters.
Commercial Dishwasher repair for Matthews businesses
Matthews combines a walkable downtown restaurant row with heavy retail along US-74 and a busy medical corridor. We serve businesses near downtown Matthews on Trade Street, Independence Boulevard (US-74) and Sycamore Commons, including ZIP codes 28104, 28105 in Mecklenburg County, NC.
Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Matthews kitchens we check airflow, coil condition and electrical parts on every visit. Our technicians are in Matthews most days of the week, so a call from a business on Sycamore Commons usually fits into the same day's route. We document every visit with the temperatures we measured and the parts we replaced, which helps Matthews managers with inspections and budgeting. Businesses in ZIP 28104 and 28105 can book online in 30 seconds, and the first available operator calls back during business hours.
Signs you need commercial dishwasher repair
- Machine not filling or not draining
- Leaking
- Rinse not hot enough (below 180°F on hot-water units)
- Dishes not coming out clean
- Booster heater not heating
- Wash arm not spinning
What our technicians do
Low rinse temperature, failed booster heaters, pump motors, solenoids, chemical feeders and drain valves are the most common repairs. We verify final rinse temperature before we leave.
- Door and curtain repair
- Float switch repair
- Fill solenoid and drain valve replacement
- Booster heater element and thermostat repair
- Delime and cleaning
- Wash and rinse pump repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Commercial DishwasherRestaurants
Dishwasher not draining
- What we found
- Drain valve stuck with debris
- What we did
- Cleared and rebuilt the drain valve
✓ Typically fixed in one visit
- Commercial DishwasherHotels & Banquet Facilities
Dish machine final rinse at 160°F
- What we found
- Booster heater element burned out
- What we did
- Replaced the element, verified 180°F final rinse
✓ Typically fixed in one visit
- Griddle & CharbroilerFood Trucks
Griddle has a cold spot on one side
- What we found
- Clogged burner ports
- What we did
- Cleaned and adjusted the burner, checked the thermostat
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Refrigerated Display CaseBakeries
Bakery display case warm at the front
- What we found
- Evaporator iced from a bad defrost timer
- What we did
- Replaced the timer, defrosted, verified temperatures
✓ Typically fixed in one visit
- Condensing Unit & CompressorGrocery Stores & Supermarkets
Rooftop condensing unit tripping the breaker
- What we found
- Shorted condenser fan motor
- What we did
- Replaced the fan motor and checked electrical connections
✓ Typically fixed in one visit
- Commercial FryerRestaurants
Fryer won't heat before lunch
- What we found
- Weak thermopile
- What we did
- Replaced the thermopile and tested the gas valve
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Technician tip
Delime on schedule and check final rinse temperature daily — inspectors will.
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Why is my dishwasher rinse not hot enough?
Usually a failed booster heater element, thermostat or a scale-coated heater.
Do you repair low-temp chemical machines?
Yes, both high-temp and low-temp machines.
How much does commercial dishwasher repair cost in Matthews, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Matthews?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28104?
Yes. We serve Matthews and all of Matthews, NC, including ZIP codes 28104, 28105.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Matthews, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |