Prep Table Not Keeping Food Cold — Repair in Indian Trail, NC
Prep Table Not Keeping Food Cold in Indian Trail, NC? From US-74 to Indian Trail Road, we provide prep table and sandwich unit repair for Indian Trail restaurants, cafés, bars and grocery stores.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Likely causes
- Weak evaporator fan
- Bad thermostat
- Low refrigerant
- Blocked rail air duct
- Dirty condenser
What to do before we arrive
- Close the rail lid
- Move pans to the cabinet or walk-in
- Clean the condenser grille
Local service
We serve businesses near US-74, Indian Trail Road and Wesley Chapel–Stouts Road, including ZIP codes 28079 in Union County, NC.
Our technicians are in Indian Trail most days of the week, so a call from a business on Wesley Chapel–Stouts Road usually fits into the same day's route. Because we also work in Stallings and Monroe, a technician is often already nearby when a Indian Trail business calls. Union County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your prep table and sandwich unit to hold those numbers. We document every visit with the temperatures we measured and the parts we replaced, which helps Indian Trail managers with inspections and budgeting.
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Prep Table & Sandwich UnitPizzerias
Pizza prep table rail pans at 46°F
- What we found
- Dirty condenser and weak evaporator fan
- What we did
- Cleaned the condenser, replaced the fan motor, rail back to 39°F
✓ Typically fixed in one visit
- Griddle & CharbroilerFood Trucks
Griddle has a cold spot on one side
- What we found
- Clogged burner ports
- What we did
- Cleaned and adjusted the burner, checked the thermostat
✓ Typically fixed in one visit
- Walk-In CoolerBreweries & Taprooms
Keg walk-in short-cycling on hot afternoons
- What we found
- Failed run capacitor and pitted contactor
- What we did
- Replaced capacitor and contactor, tested compressor under load
✓ Typically fixed in one visit
- Walk-In FreezerSchools & Universities
Ice building up on the freezer floor near the door
- What we found
- Torn door gasket and failed door-frame heater
- What we did
- Replaced the gasket and frame heater wire
✓ Typically fixed in one visit
- Draft Beer & Keg CoolerBreweries & Taprooms
Foamy pours on every tap
- What we found
- Glycol chiller pump failing, lines warming
- What we did
- Replaced the glycol pump and topped up glycol
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Walk-In CoolerRestaurants
Walk-in cooler at 48°F before dinner service
- What we found
- Evaporator fan motor seized; coil starting to ice
- What we did
- Replaced the fan motor, cleared the coil, verified 36°F box temperature
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Frequently asked questions
Why is my prep table not cold?
Most often: dirty condenser; weak evaporator fan; blocked rail air duct; low refrigerant.
How much does prep table and sandwich unit repair cost in Indian Trail, NC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Indian Trail?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 28079?
Yes. We serve Indian Trail and all of Indian Trail, NC, including ZIP codes 28079.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Indian Trail, NC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |