Ice Machine Not Making Ice — Repair in Fort Mill, SC
Ice Machine Not Making Ice in Fort Mill, SC? When a ice machine goes down in Fort Mill, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit.
Likely causes
- Water supply off or clogged filter
- Bad sensor or control board
- Scale on the evaporator
- Dirty condenser
- Failed water inlet valve or pump
What to do before we arrive
- Check the water supply valve is open
- Check the water filter
- Make sure the machine has airflow
- Note any flashing lights or codes
Local service
We serve businesses near Main Street, Baxter Village and Kingsley Town Center, including ZIP codes 29707, 29708, 29715 in York County, SC.
Our technicians are in Fort Mill most days of the week, so a call from a business on Kingsley Town Center usually fits into the same day's route. Because we also work in Tega Cay and Indian Land, a technician is often already nearby when a Fort Mill business calls. York County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your ice machine to hold those numbers. We document every visit with the temperatures we measured and the parts we replaced, which helps Fort Mill managers with inspections and budgeting.
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Ice MachineConvenience Stores & Gas Stations
Ice machine showing a flashing error light
- What we found
- Water inlet valve not opening
- What we did
- Replaced the inlet valve and verified full fill
✓ Typically fixed in one visit
- Ice MachineHospitals & Senior Living
Nugget ice machine leaking onto the floor
- What we found
- Cracked drain hose behind the unit
- What we did
- Replaced the hose, cleaned and sanitized the machine
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
- Coffee & Beverage EquipmentCafés & Coffee Shops
Coffee brewer not hot
- What we found
- Scale-coated heating element
- What we did
- Replaced the element, descaled the tank
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Frequently asked questions
Why is my ice machine not making ice?
Most often: scale on the evaporator; water supply off or clogged filter; failed water inlet valve or pump; dirty condenser.
How much does ice machine repair cost in Fort Mill, SC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Fort Mill?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 29707?
Yes. We serve Fort Mill and all of Fort Mill, SC, including ZIP codes 29707, 29708, 29715.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Fort Mill, SC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |