Commercial Freezer Not Freezing — Repair in Fort Mill, SC
Commercial Freezer Not Freezing in Fort Mill, SC? When a reach-in freezer goes down in Fort Mill, food, sales and inspections are on the line.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
Our technicians arrive with common parts and fix most problems on the first visit.
Likely causes
- Failed fan motor
- Compressor or start component failure
- Dirty condenser
- Defrost failure
- Door gasket leak
What to do before we arrive
- Move product to another freezer
- Keep the door closed
- Check for heavy frost on the coil
Local service
We serve businesses near Main Street, Baxter Village and Kingsley Town Center, including ZIP codes 29707, 29708, 29715 in York County, SC.
Many of our Fort Mill customers are along Main Street and the I-77 and US-21 corridor near Carowinds, where busy kitchens run reach-in freezer equipment hard from open to close. We document every visit with the temperatures we measured and the parts we replaced, which helps Fort Mill managers with inspections and budgeting. Summer heat in the Charlotte region pushes condensers and compressors to their limit; for Fort Mill kitchens we check airflow, coil condition and electrical parts on every visit. York County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your reach-in freezer to hold those numbers.
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Commercial OvenPizzerias
Conveyor pizza oven not reaching temperature
- What we found
- Failed igniter and flame sensor
- What we did
- Replaced igniter and sensor, verified bake temperature
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Commercial Range & CooktopRestaurants
Range pilots keep going out
- What we found
- Worn thermocouples on two burners
- What we did
- Replaced thermocouples, cleaned pilot assemblies
✓ Typically fixed in one visit
- Refrigerated Display CaseGrocery Stores & Supermarkets
Glass-door merchandiser fogging up
- What we found
- Door anti-sweat heater failed
- What we did
- Replaced the door heater and checked the controller
✓ Typically fixed in one visit
- Commercial FryerConvenience Stores & Gas Stations
Fryer overheating and tripping the high-limit
- What we found
- Temperature probe failing
- What we did
- Replaced the probe and calibrated the controller
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Frequently asked questions
Why is my commercial freezer not freezing?
Most often: defrost failure; failed fan motor; dirty condenser; door gasket leak.
How much does reach-in freezer repair cost in Fort Mill, SC?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Fort Mill?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Do you serve ZIP code 29707?
Yes. We serve Fort Mill and all of Fort Mill, SC, including ZIP codes 29707, 29708, 29715.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Fort Mill, SC.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |