Atosa Repair in Blakeney, Charlotte
Our Atosa repair service covers all of Blakeney, Charlotte.
- Licensed & insuredCommercial refrigeration and kitchen equipment technicians
- $135 service callClear price before any work starts
- $50 off your repairWhen you book online or mention the website
- Warranty on every job30-day labor, 90-day parts, extended 1, 3 or 5 years on select work
- Open 7 days a weekMon–Sat 8 AM–6 PM · Sun 10 AM–3 PM
- Same-day serviceWhen you call early — trucks stocked with common parts
We know the local businesses, the building types and how hot a Blakeney kitchen gets in July. Atosa makes reach-ins, prep tables, undercounters and ice machines, and we repair them on-site.
Atosa service for Blakeney businesses
Blakeney's shopping center and the Rea Road corridor are full of restaurants, grocery stores and fast casual concepts. We serve businesses near Blakeney Shopping Center, Rea Road and the I-485 and Rea Road interchange, including ZIP codes 28277 in Mecklenburg County, NC.
Mecklenburg County health inspectors check cold-holding at 41°F or below and hot-holding at 135°F or above — we repair your Atosa to hold those numbers. Because we also work in Rea Farms and Piper Glen, a technician is often already nearby when a Blakeney business calls. Our technicians are in Blakeney most days of the week, so a call from a business on the I-485 and Rea Road interchange usually fits into the same day's route. We document every visit with the temperatures we measured and the parts we replaced, which helps Blakeney managers with inspections and budgeting.
Atosa problems we fix in Blakeney
- Atosa ice machine: bad taste or odor in the ice
- Atosa ice machine: error lights or flashing codes
- Atosa reach-in refrigerator: gasket torn or door sagging
- Atosa reach-in refrigerator: not cold enough or temperature swings
- Atosa reach-in freezer: constant running
- Atosa reach-in freezer: heavy frost on the coil or walls
- Atosa prep table and sandwich unit: top rail pans above 41°f
- Atosa prep table and sandwich unit: lid hinge broken or lid not closing
- Atosa undercounter and worktop refrigerator: compressor very hot or tripping
- Atosa undercounter and worktop refrigerator: not holding temperature during service
- Atosa bar cooler and back bar: unit running constantly
- Atosa bar cooler and back bar: frost inside the cabinet
Atosa equipment we repair
Save $50 on your repair
Book online or mention our website when you call and we take $50 off the repair. The service call is a flat $135, and you get a clear price before any work begins — no surprises.
Typical jobs we handle
Examples of common repairs on commercial refrigeration and kitchen equipment.
- Reach-In RefrigeratorCafés & Coffee Shops
Dairy reach-in warm at the top shelf
- What we found
- Evaporator fan blade cracked, poor airflow
- What we did
- Replaced fan blade and motor, rebalanced airflow
✓ Typically fixed in one visit
- Ice MachineBars & Nightclubs
Ice machine making half the usual ice
- What we found
- Heavy scale on the evaporator plate
- What we did
- Descaled, sanitized and replaced the water filter
✓ Typically fixed in one visit
- Prep Table & Sandwich UnitRestaurants
Sandwich unit lid won't stay open
- What we found
- Broken lid hinge pin
- What we did
- Replaced the hinge set and adjusted the lid
✓ Typically fixed the same day
- Bar Cooler & Back BarBars & Nightclubs
Back-bar cooler bottles not cold
- What we found
- Thermostat out of calibration
- What we did
- Replaced the thermostat and set to 36°F
✓ Typically fixed in one visit
- Reach-In FreezerPizzerias
Reach-in freezer frosting up every few days
- What we found
- Defrost heater open circuit
- What we did
- Replaced the defrost heater and tested a full defrost cycle
✓ Typically fixed in one visit
- Undercounter & Worktop RefrigeratorRestaurants
Chef base losing temperature during the rush
- What we found
- Front grille and condenser clogged with grease
- What we did
- Cleaned the condenser, replaced a worn drawer gasket
✓ Typically fixed in one visit
- Ice MachineHotels & Banquet Facilities
Floor ice machine not harvesting
- What we found
- Faulty harvest assist and a weak water pump
- What we did
- Replaced both parts and ran test cycles
✓ Typically fixed in one visit
- Reach-In RefrigeratorRestaurants
Two-door reach-in at 45°F on the line
- What we found
- Condenser fan motor not running
- What we did
- Replaced the condenser fan motor and cleaned the coil
✓ Typically fixed in one visit
Examples for illustration. Every job is diagnosed on site; parts, time and price depend on the equipment.
Other brands in Blakeney
Our warranty
Labor warranty on every repair.
Parts warranty on every part we install.
Extended warranty available on select repairs and installations. The exact term is written on your estimate before work starts.
Frequently asked questions
Do you repair Atosa equipment in Blakeney?
Yes. We repair Atosa ice machine, reach-in refrigerator, reach-in freezer, prep table and sandwich unit, undercounter and worktop refrigerator, bar cooler and back bar for businesses throughout Blakeney, Charlotte.
Are you an authorized Atosa dealer?
No — we are an independent commercial service company. We repair Atosa equipment and warranty our work for 30 days labor and 90 days parts.
How much does Atosa repair cost in Blakeney, Charlotte?
The service call is a flat $135, which covers the trip and diagnosis. After diagnosis you get a written price for the repair before any work starts, and you save $50 on the repair when you book online or mention our website.
What are your hours in Blakeney?
We are open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). Call (980) 983-2911 or send a request online and the first available operator will call you back.
Hours & contact
Commercial Appliances is open Monday through Saturday from 8:00 AM to 6:00 PM, and Sunday from 10:00 AM to 3:00 PM (Eastern Time). We serve Blakeney, Charlotte.
Phone: (980) 983-2911
Email: omnicommercialrefrigeration@gmail.com
Based in Charlotte, NC. We are a mobile service company — our technicians come to your business.
| Monday | 8:00 AM – 6:00 PM |
|---|---|
| Tuesday | 8:00 AM – 6:00 PM |
| Wednesday | 8:00 AM – 6:00 PM |
| Thursday | 8:00 AM – 6:00 PM |
| Friday | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 6:00 PM |
| Sunday | 10:00 AM – 3:00 PM |